Low-cost trade data platforms

List of the contents of this article:

• 1,Low-cost trade data platforms What should I do if the engine water temperature is too high?
• 2, Can the car still be driven when the water temperature is high? How to deal with it; the reason for the high water temperature of the car and the maintenance method
• 3, What is the solution to the high water temperature of the engine?

What should I do if the engine water temperature is too high?

1. When the engine water temperature is high, first check whether the water temperature meter is faulty. If there is a fault, it needs to be replaced.Then check whether there is a shortage of water in the water tank, whether the water supply pipe and radiator are cracked or leaking. In addition to direct observation, the water leakage part can also be checked by inflation.

2. The solution to show that the engine water temperature is too high: slow down immediately, downshift, and pull over slowly. When the front cover of the car cools down, remove it, and then check the oil and water tank after cooling the engine. If there is no problem, check the fan in the car and whether it is running normally.

3. Solution to excessive water temperature: check whether the water tank is leaking, open the water tank, and see if the water level is below MIN. If the water level is very low, it is likely to be leaking. Add water, open the exhaust screw near the engine to exhaust, and check the water leakage point. Gas in the water tank can also cause high water temperature.

Can the car still be driven when the water temperature is high? How to deal with it; the reason for the high water temperature of the car and the maintenance method

1. If the water temperature is too high during driving, it is recommended that the owner directly call the rescue call and find a trailer to send the car to the 4s store for repair, because the car cannot continue to drive after boiling, which will damage the engine.Insufficient coolant in the car is the most likely reason for the car to boil. Usually, before driving, we need to open the engine cover and check the remaining coolant.

2. How to deal with excessive water temperature: During normal driving, the water temperature alarm light shows red, indicating that the water temperature of the engine has been higher than the normal working temperature. The owner needs to stop and check immediately. If you continue to drive, there will be a boiling phenomenon. If it is serious, it will cause the car water tank to be scrapped and increase the owner's maintenance. The cost of the car.

3. When the water temperature is too high, slow down directly and drive the car to a safe zone and park. Do not turn off the engine directly after parking. Because the water temperature is too high, turning off the engine immediately will cause some soft metals to fall, and some will even cause the cylinder to stick, let the engine idle in place for a while, and adjust the air conditioner to the warm air gear, which will The air volume is turned up to the maximum temperature.

4. Solution to excessive water temperature: check whether the water tank is leaking, open the water tank, and see if the water surface height is below MIN. If the water level is very low, it is likely to be leaking. Add water, open the exhaust screw near the engine to exhaust, and check the water leakage point. Gas in the water tank can also cause high water temperature.

What is the solution to the high water temperature of the engine?

When the engine water temperature rises, the following solution can be adopted: replace the water temperature sensor. If the pot is not opened, it only indicates that the water temperature is high, and it may also be caused by the inaccuracy of the water temperature sensor. Replace the thermostat. The thermostat can't be turned on, so cold and hot water are not circulated.

The way to deal with high engine water temperature is to replace the water temperature sensor.If the pot is not opened, it only indicates that the water temperature is high, and it may also be caused by the inaccuracy of the water temperature sensor. Replace the thermostat. The thermostat can't be turned on, so cold and hot water are not circulated. After the water temperature reaches 90 degrees, open the cabin cover to touch the heat of the water pipe near the engine.

Replace the engine water temperature meter: Damage to the engine water temperature meter may cause the temperature to be too high, and the water temperature meter should be replaced. Replace or repair defective parts: If all the above methods cannot solve the problem, check the engine at a professional vehicle repair shop. It may be necessary to replace or repair the engine cooling system, fan, water pump and other defective parts.