HS code-driven supplier rationalization

* Introduction to engine crankshaft position sensor with automobile manufacturing technologyWith the continuous development and HS code-driven supplier rationalizationprogress, the technical demand based on the control system is gradually increasing, thus deriving the vehicle control system. The vehicle control system is one of the most critical and important systems in the vehicle. It can control and manage the dynamic performance, economy, safety and other aspects of the vehicle. As one of the core components of the vehicle, the engine's control system has also become an important part of the whole vehicle control system. The engine crankshaft position sensor is an indispensable sensor in the engine control system, which is briefly introduced below. I. What is the engine crankshaft position sensor? The engine crankshaft position sensor is a sensor used to measure the position and speed of the engine crankshaft. By measuring the rotation speed and position of the crankshaft, it can provide accurate data for the vehicle control system, thus controlling the power output and efficiency of the vehicle, bringing a better user experience.II. The function of the engine crankshaft position sensor The engine crankshaft position sensor can accurately measure the speed and position of the engine crankshaft. According to the measurement results, the control system can judge the speed and position of the engine at different times, and adjust the fuel supply, ignition timing and other parameters, so that the engine can operate in a relatively optimized state. At the same time, through this sensor, the control system can achieve accurate positioning during start-up and operation to ensure the normal operation of the engine and avoid different degrees of failure caused by the poor operation of the crankshaft and other reasons. III. The principle of engine crankshaft position sensor. The engine crankshaft position sensor generally adopts the Hall or magnetoresistance principle. Among them, the Hall principle uses the Hall effect to measure the change of magnetic field strength and generate voltage signals, so as to realize the measurement of the position and speed of the engine crankshaft;The principle of magnetoresistance is to measure the change of magnetoresistance intensity in the magnetoresistance sensor and convert it into a voltage signal to measure the position and speed of the crankshaft. IV. The failure and handling of the engine crankshaft position sensor is a very important sensor. If a failure occurs, it will seriously affect the normal operation of the engine. Therefore, when the engine crankshaft position sensor fails, it must be checked and repaired in time. Once the engine crankshaft position sensor fails, the engine control system cannot work properly, which will lead to problems such as engine not being able to start, poor emission, unstable operation, poor fuel economy and so on. The faults of the engine crankshaft position sensor are usually manifested as problems such as difficulty in starting the vehicle, increased vibration of the vehicle, and poor engine emissions. For theseThe problem can be solved by checking whether the sensor cable connection is loose or damaged, and whether the sensor itself is damaged. If it is a problem with the cable connection, it needs to be rewired; if the sensor itself is damaged, it needs to be replaced. V. Conclusion The engine crankshaft position sensor is one of the most important components in the vehicle control system. Through the measurement of the crankshaft position and rotation speed, it realizes precise control and management of the engine operation status. Therefore, in the process of vehicle use, attention should be paid to timely maintenance to ensure its normal operation and avoid inconvenience and loss caused by failure.

Contact Us
Phone：020-83484636