1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Industry-specific tariff code reference-APP, download it now, new users will receive a novice gift pack.
1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Real-time import duties calculator
author: 2024-12-23 22:02How to find reliable global suppliers
author: 2024-12-23 21:40Trade data for GDP correlation analysis
author: 2024-12-23 21:27Refined metals HS code references
author: 2024-12-23 20:48Country trade missions and HS code references
author: 2024-12-23 20:19Regional value content by HS code
author: 2024-12-23 22:00Identify duty-free items via HS code
author: 2024-12-23 21:17How to find authorized economic operators
author: 2024-12-23 20:56Refined metals HS code references
author: 2024-12-23 20:40181.63MB
Check124.86MB
Check756.58MB
Check127.57MB
Check713.78MB
Check629.34MB
Check166.85MB
Check951.59MB
Check435.94MB
Check419.88MB
Check354.42MB
Check418.41MB
Check556.44MB
Check532.56MB
Check216.72MB
Check945.77MB
Check173.86MB
Check967.27MB
Check674.49MB
Check175.58MB
Check695.56MB
Check697.88MB
Check931.42MB
Check255.25MB
Check668.58MB
Check796.99MB
Check193.61MB
Check112.95MB
Check464.15MB
Check629.73MB
Check122.26MB
Check441.89MB
Check554.56MB
Check652.47MB
Check967.26MB
Check898.25MB
CheckScan to install
Industry-specific tariff code reference to discover more
Netizen comments More
1577 HS code mapping for ASEAN countries
2024-12-23 22:56 recommend
1369 HS code-driven freight route adjustments
2024-12-23 22:55 recommend
620 Supply contracts referencing HS codes
2024-12-23 22:02 recommend
1742 Medical implants HS code classification
2024-12-23 21:05 recommend
2342 MRO HS code checks
2024-12-23 21:02 recommend